loading system configuration
loading user configuration from /users/willend/.mcstas/3.x-dev/mccode_config.json
loading override configuration from /users/willend/McCode/tools/Python/mctest/../mccodelib/mcstas-test/McStas_DUAL_A100_DMSC/mccode_config.json
INFO: Using directory: "4"
INFO: Using existing c-file: ./Test_Magnetic_Constant.c
INFO: Using existing binary: ./Test_Magnetic_Constant.out
INFO: ===
--------------------------------------------------------------------------
WARNING: No preset parameters were found for the device that Open MPI
detected:

  Local host:            r6n22
  Device name:           mlx5_0
  Device vendor ID:      0x02c9
  Device vendor part ID: 4123

Default device parameters will be used, which may result in lower
performance.  You can edit any of the files specified by the
btl_openib_device_param_files MCA parameter to set values for your
device.

NOTE: You can turn off this warning by setting the MCA parameter
      btl_openib_warn_no_device_params_found to 0.
--------------------------------------------------------------------------
Simulation 'Test_Magnetic_Constant' (/users/willend/TESTS/2022-11-01/McStas_DUAL_A100_DMSC_5e7/Test_Magnetic_Constant/Test_Magnetic_Constant.instr): running on 2 nodes (master is 'r6n22.esss.dk', MPI version 3.1).
Have found 2 GPU devices on rank 1. Will use device 1.
Have found 2 GPU devices on rank 0. Will use device 0.
By should be -0.000068 T, to be able to rotate a 5.000000 AA neutron
 180.000000 degrees over a length of 0.200000 m
[Test_Magnetic_Constant] Initialize
INFO: Set_pol(polSetter): Setting polarization to (1.000000, 0.000000, 0.000000)
By should be -0.000068 T, to be able to rotate a 5.000000 AA neutron
 180.000000 degrees over a length of 0.200000 m
[Test_Magnetic_Constant] Initialize
INFO: Set_pol(polSetter): Setting polarization to (1.000000, 0.000000, 0.000000)
[r6n22.esss.dk:4144767] 1 more process has sent help message help-mpi-btl-openib.txt / no device params found
[r6n22.esss.dk:4144767] Set MCA parameter "orte_base_help_aggregate" to 0 to see all help / error messages
Failing in Thread:1
call to cuMemcpyDtoHAsync returned error 700: Illegal address during kernel execution

--------------------------------------------------------------------------
Primary job  terminated normally, but 1 process returned
a non-zero exit code. Per user-direction, the job has been aborted.
--------------------------------------------------------------------------
--------------------------------------------------------------------------
mpirun detected that one or more processes exited with non-zero status, thus causing
the job to be terminated. The first process to do so was:

  Process name: [[18624,1],1]
  Exit code:    1
--------------------------------------------------------------------------